Skip links

Creating a Blockage A55

This walkthrough explains how to create a plan for blockages.

Location Overview

The blue dot shows your current position.

Select the first box location by selecting Add Point at Location.

You can also tap anywhere on the map to manually select your location.


Cover Type

Next, tap on an icon to select your cover type.

Scrolling downward shows more available cover types.

Tap Next to progress.


Surface Type

Select the surface type for your first point.

Multiple surfaces can be selected where required.

Tap Next to progress.


Number of Ducts

Specify the number of ducts by dragging the slider across.


Duct Clearance

You are now presented with the ducts based on your previous answer.

Tap and drag so that the circles resemble the actual duct formation.

Now tap on a duct to specify which of them requires clearance.

For more than one blockage, a separate blockage A55 would be carried out.


Number of Cables in Situ

Use the slider to now specify the number of cables in situ.

Proceed to the next stage by tapping Next.


Bore Full Percentage

Use the slider again to specify the estimated percentage of the bore that is full.

You will notice that the slider has a percentage based increments to help you select the best option.

Tap Done to proceed.


Point, Cover and Surface Type

Add your second point, and select its cover type.

Additionally, provide a surface type for this point.


Adding a Blockage

You will now see the two points connected by the red line.

Choose to Add Blockage at Location, or manually drop a pin on the line where it is needed.

Zoom in and out any time by pinching the screen to assist with this process.


Surface Type of Blockage

Specify the surface type of the blockage before proceeding.


Second Blockage/Finalise Plan

Finally, you can choose to add a second blockage if another exists, or select Finalise Plan.

Something not right? Head back using the arrow located on the top left at any time.


Finalising the Plan

Enter some final details for the job, beginning with inputting the Job and Estimate Number.

Tap to toggle the requirements for Red Route/Bus Lane and Private.

Add the Exchange of the location.


Finalising the Plan (cont.)

Specify the Duct Section and Cable Size.

Next, select the Traffic Management option needed from the dropdown menu.

Finally, provide some contact and date details before tapping Finalise Plan.


Map Overview

The map overview shows coordinates from the first point to the second, including the blockage(s) coordinates in between.

The lines show the distance of the first and second points from the blockage,

Tap Save to progress.


Completing the Plan

Selecting My Plans will now return you to the main screen.